Combined with NMS-STIM (Neuromuscular Stimulation) and ETS (EMG Triggered Stimulation) - 3 devices in 1 compact unit.
Used as a learning tool for both patient and clinician with emphasis on improving treatment techniques in the use of EMG and Neuromuscular stimulation.
- Dual channel EMG (Biofeedback) combined with NMS-STIM (Neuromuscular Stimulation) & ETS (EMG Triggered Stimulation).
- Passive and Active phases: EMG and NMS in one programme.
- Manual and Automatic threshold control.
- EMG Biofeedback between stimulation (muscle activity and tiredness indication when using muscle stimulation).
- Stand alone device or used in conjunction with established multilingual software.
- Pre-set neuromuscular Stimulation modes for: Continence, Sports, Rehab.
- Custom programmes enabling up to 5 phases (any of: STIM W/R-MODCONT- ALT, EMG, ETS) to be set up in each programme.
- Multilingual LCD screen and voice prompts for Biofeedback.
- For home users: Produces and prints (with the optional PC Software) the comprehensive patient progress reports on a day to day basis providing average readings (2 channels) on work/rest, peak, onset and muscle release times, work and rest deviations and the average mA current.
- Used as a learning tool for both patient and clinician with emphasis on improving treatment techniques in the use of EMG and Neuromuscular stimulation.
- Multilingual LCD screen prompts.
- 4 x AA batteries {No mains required}
Interested? Get a Quote:
EMG550
Neurotrac MyoPlus2 biofeedback unit
EMG (Biofeedback)
- 1.0 Dual channel EMG
- 1.1 EMG Range: 0.2 to 2000 μV RMS (continuous)
- 1.2 Sensitivity: 0.l μV RMS
- 1.3 Accuracy: 4% of μV reading +/-0.3 μV at 200 Hz
- 1.4 Selectable Bandpass filter - 3db Bandwidth,
- a. Wide: 18 Hz +/- 4 Hz to 370 Hz +/- 10% - Reading below 235 microvolts 10 Hz +/-3 Hz to 370 Hz +/- 10% - Reading above 235 microvolts
- b. Narrow: 100 Hz +/- 5% to 370 Hz +/- 10%
- 1.5 Notch filter: 50 Hz (Canada 60Hz) - 33 dbs (0. 1% accuracy)
- 1.6 Common Mode Rejection Ratio: 130 dbs Minimum @ 50 Hz
- 1.7 a. Batteries: 4 x 1.5V ( AA battery)
- b. Optional Charger: CE approved.
- 1.8 Work / Rest periods: 2-99 seconds
- 1.9 Number of Trials: 1-99
STIM (Neuromuscular Stimulation)
- 2.1 2 channel Stimulator
- 2.2 Amplitude: 0-90 mA into 500 Ohm load - actual mA will tend to be less
than indicated due to Electrode impedance: at 1000 Ohms load (Electrodes
in poor condition) the maximum will be limited to 75 mA, at 1500 Ohms
load the maximum will be limited to 50 mA. - 2.3 Type: Constant current, maximum output
voltage 70 Volts +5 / -10 Volts - 2.4 Waveform: Symmetrical, rectangular,
bi-phasic with net zero DC current - 2.5 Pulse width selection: 50-450 μS (2% accuracy)
- 2.6 Pulse rate selection: 2-100 Hz (2% accuracy)
- 2.7 Work / Rest periods: 2-99 seconds
- 2.8 Time 1 - 99 minutes
- 2.9 Ramp up time: 0.1 - 9.9 seconds
- 2.10 Preset and user programmable treatment Programs
- 2.11 Automatic output shut off with detection of open electrode above 0.5 mA
Battery: Low battery indication at 5.4 volts +/- 0.2 volts, automatic shut off
when voltage dropps below the low indication. Replace the batteries immediately!
The device goes off automatically when not in use (energy saving): for example
when in settings and no key pressed over 1 minute, when in stimulation mode
(home screen) and all channels are 0mA.
Environmental Conditions for use:
+10 to +30 degrees Centigrade. 0-90% Humidity.
Environmental conditions for storage & transport:
-10 to +50 degrees Centigrade. 0-90% Humidity.
Physical:
Dimensions: Length 150 mm, Width 89 mm, Depth 35 mm.
Weight:
MyoPlus2 device: 0.16 Kg (without batteries).
Other items that may be of interest to you:
Accessories:
EMG551
Neurotrac MyoPlus2 software
RB450
PALS Platinum self-adhesive electrodes-pack of 4 (25mm)
RB410
PALS Platinum self adhesive electrodes-pack of 4 (33x54mm)
RB430
PALS Platinum self adhesive electrodes-pack of 4 (50x50mm)
RB440
PALS Platinum self adhesive electrodes-pack of 4 (33x54mm)